Table of Contents
Design and Fabrication Of Tension less Bike Full Report Download
Abstract：
一辆汽车是用于运输乘客的轮式机动车，该机动车也承载自己的发动机或电机。但通常，两个惠勒使用了大多数经济的人。摩托车是世界许多地区的最实惠的机动运输形式之一，而且为世界上大部分人口;它们也是最常见的机动车类型。在全球范围内使用约2辆摩托车（包括摩托车，电机踏板车和其他动力的两个和三轮车），或每1000人摩托车约33辆摩托车。当人们因各种原因而选择骑摩托车，这些原因越来越实用，与骑手选择一个动力的两轮车，作为不常见和昂贵的公共交通系统的成本有效的替代方案，或者作为避免或减少城市拥堵影响的手段。在允许的地方，车道分裂，也称为过滤，允许摩托车使用车辆之间的空间来通过静止或缓慢的交通。在这种摩托车上，主要发生的主要事故由于粗心而导致的主要事故发生。他们中的一些人忘了拿走侧面，他们开始用那个侧面驾驶。这导致事故。有时如果我们要长时间驾驶，我们的自行车或我们的自行车可能会有气泄漏的机会。 In that time there is no puncher shop nearby us. So we get into trouble.
介绍
While people choose to ride motorcycles for various reasons, those reasons are increasingly practical, with riders opting for a powered two-wheeler as a cost-efficient alternative to infrequent and expensive public transport systems, or as a means of avoiding or reducing the effects of urban congestion. In places where it is permitted, lane splitting, also known as filtering, allows motorcycles to use the space between vehicles to move through stationary or slow traffic.
在这款摩托车中，主要发生了由于粗心的意外。他们中的一些人忘了采取侧面，他们开始驾驶驱动器有可能在我们的自行车中泄漏。在那段时间内，没有打孔器店铺。这导致事故。有时如果我们将到过很长时间的美国。所以我们陷入困境。
许多工程师发现减少自行车张力的解决方案。但它不会那么有效，而不是我们的发现。
Our aim is to reduce the tension of one who is driving the vehicle. Because some of the carelessness leads to a death. So every time we always aware of that. So our mini project helps a little bit to reduce those kind of incidents. Our objective is to inflate the tyre in some emergency conditions where there is no helping hands.This method is one of the easiest methods and also the cheapest methods
我们的迷你项目由两件事组成：
1.侧展示指示器调制
2.压缩机减去重量
These two things are most important for all the bikes. All the bike riders knew how important these two things are. We are doing some of the alterations in the bike to make a successful of these two.
COMPRESSOR IN BIKE:
打孔器通常发生的东西自行车。如今大多数摩托车公司都推出了无管轮胎。如果发生车轮，它会慢慢减少空气。无论如何，这也需要空气来移动一定距离。
In the same way in the normal tube present in the tyres also . But in this normal tube using tyres the air will leaking out very rapidly than compare to tubeless tyres .
如何充气：
在此，我们在我们的自行车发动机中进行了很小的修改，另外还有电视50发动机附着。然后，我们通过去除发动机的所有鳍和一些修改来使用此引擎作为压缩机。
首先让我们看看有关两个笔划发动机的引擎和细节是什么......
我们在此引擎中的修改：
我们使用不同的机械方法切割发动机的翅片。因为我们仅使用此引擎作为压缩机。所以没有机会生产热量。因为它会被忽略。而且还减少了发动机的重量，我们也切割了其他不需要的东西。有许多方法可以去除鳍;我们使用铣床除以除其他机械方法的翅片。
See Project on Tyre Inflation:
侧面：
侧面是我们高级工程师最漂亮的公司之一，而且附加到骑自行车而不是中心站立大部分时间人们在他们的自行车上只使用侧面，因为它很容易使用与中心支架进行比较。
OUR SOLUTION REGARDING THIS PROBLEM:
我们的解决方案基于钥匙的原理和锁定在自行车中的锁定，即在使用侧面支架时，直到侧面支架才能开始自行车。然后，如果我们采取侧面支架并使用初学者开始自行车，那么它将开始这是我们的新方法发现现有的新方法。
OUR MECHANISM IN THIS SOLUTION:
We have added a additional circuit to the existing circuit. We have taken a wire or looped a wire from the ignition system and connect it to a plate. In the mean while the other wire is looped from earth or from ground and it is connected to the other plate. Now these wire are been kept in the side stand switch.
ADVANTAGES：
• For the side stand we provide a manual setup.
• If the battery becomes the chargeless battery sensors will not produce the beep sound properly, but our set up will not like this.
•如果我们无助地膨胀轮胎，我们的设置将有助于很多。
• It can also be done by a person having basic knowledge of automobiles.
•成本较少。
• Less maintenance required.
CONCLUSION:
The primary goal of this mini project is to find out some useful things which makes us feel less tension while we driving a two wheeler. Thus we find out the things which makes useful for many people. In this busy world we have a lots of work to do. In this busy schedule, it will happened to forgot small things. So we hope that our project helps a little bit to the people. Our future aim is to fit these compressor inside the engine guard. Some of the bikes like Yamaha, fazer and most of the sports bike have this engine guard. If we will fit this compressor in this engine means it will helps a lot.
